All posts liked by lynchfourtwenty
Will the top be a spherical bearing instead of rubber?
Will they have adjustable camber and caster on the top plates?
Will the part that mounts the strut to the knuckle have provisions for the b...
Oh wow...stumbed across this:
Nissan Sentra Service Manual: Rear disc brake - Removal and installation - Brake system - Brakes
Find (and learn) something new every day!
1992 SE-R / Datsun 510 Owner
That will not be an issue here. They are well thought out. :bigthumbup:
Direct fitment !! Plug and Play just like our 5 lug swap kit with b15 knuckles !!!
Obsessed or something.. mention my name in threads I'm not even in.. good God
Surprisingly, JWT is not being responsive. I've emailed several times but am getting no response.
With respect to my Consult cable, one thing I noticed was that the TPS shows that it's open, ev...
Yeah I set the idle at about 8-850 right now. Doenst seem to have fixed the hard start issue but the car runs great when it warms up lol (as it did before but yeah). I'm pretty stumped and dont kno...
I've found the most important mount of all is the rear trans mount in these cars. FYI..
Rewire the fuel pump with a relay. Sounds like it's arcing to ground somewhere when it wants more amps which is blowing your fuse. What was your end to end resistance on the fuel pump circuit? I...
Either
1) Trying to get post count up to post a thread
2) Trying to get post count up to post a for sale thread
3) Both.
And about 2% of Nissan techs have ever removed anything other than the rocker cover on an SR20 engine.
I flipping hate how little room is in the Z32 engine bay with the OEM engine. SR20 looks way better in there.
Well im just going to give the -3an with no restrictor a shot. If the turbo blows up, i will update you guys.
Sorry, but that is just plain wrong. Speedometer input to ECU is utilized for a multitude of purposes. Other from the speed limiter, it can be used to raise the idle speed while rolling the car. Th...
$1114 to my door. Covered paypal fee+shipping and v-band for the exhaust housing.
i got mine from rock auto. be careful with spacing. when i di my clutch i threw it in and didnt know it would hit the flywheel. snapped it and after talking to pat Klutch realized i had to use wash...
it is crank position sensor 100% sure
Today I went ahead and took the jackstands out from underneath and hoisted the engine from above by some studs on the block. I put a pry bar in that little slot near the bell housing between the pa...
Ha!! great minds think alike
I just did thie same last week putting a p11 trans in an nx. That way its plug and play for 32v and 70V trans without cutting the harness:bigthumbup:
I was going to say "AARP member"... but I had a change of heart and removed it and left that open like a Mad Libs for fun. And along with the fact that another member of the AARP organization is in...