All posts liked by lynchfourtwenty
Josh got it!
On a positive note, you will remember next time! That's how you learn. :bigthumbup:
https://i.imgflip.com/1dxet4.jpg
I mentioned it in texts before this thread was created. However, you can have the prize though, I got a cheese steak and a bunch of beers out of the deal.
Thanks Ian!
Ok so I slowly jacked up the trans with the shift linkage connected. After about an inch, the shifter in neutral now sits MUCH closer to normal. I just have to get under there tomorr...
If you're on a budget, Fortune Auto is the only budget solution worth recommending. Yes, look into them instead.
No since Todd left Saturday I put it together myself. Haven't had anyone else here to help.
I removed both the shift linkage and shifter stabilizer bar to remove the gearbox.
And to answer your o...
Check to make sure you bolted the rear motor mount bracket / rear motor mount correctly. Only thing i can think of that would cause that.
Also, SR20NYC has always given great prices on OEM Nissan parts and is easy to get ahold of.
It can be used with either stock ECU or Nismotronic equipped ECU. The latter is always better, since you can tune dwell in Nismotronic.
You are correct, smart coils are way cheaper. It is es...
Stock mains are good for 500-550+ WHP. No sense is risking going with anything else due to having to get align hone.
Looking good!
I understand how important the chat box is for some people, which is why I'm planning to have it for the initial roll-out if at all possible (although it will be the most difficult thing I'll have ...
It's all about seat time with TIG. Keep at it and you'll see significant improvement in the coming months!
Also a quality gas lense/cup setup is a great investment from the start.
Nice updates! I hope you don't wheel hop with those !
It honestly depends on each car and what tire and suspension setup the car has.
I generally try to get the car's low boost to be whatever I would want to run in 1/2nd gear if traction limited an...
Hey VMK,
What is your base timing??
I can grab my current bin for you (200+ whp), but it is pretty similar to those already posted. If your tuner thought 20deg timing adv at wot on that first...
Has any body noticed this about the SE-R
I put it back the way it was, meaning reconnected the EGR solenoid harness.
Then I added back the water temp sensor harness from a junkyard B13. And also replaced the o2 sensor.
Good as gold...
I used a double male nipple with 2 90*hoses from my stash and it works great. I'm assuming that everyone else is a relatively cheap bastard like me and has bins of saved hoses, clamps, nuts, & bol...
My $6 spoiler support project
^^^ yes you can, ya don't wanna spin the motor more than 8k to be super safe. I'm running 16ve in with a VET ex. It'll do the job. The Vet ex cam will help with spool on the big turbos.
Yep, what a shame, all those nice build threads left in the dust. :(
I guess because it is so much easier to upload pictures and everyone loves them fancy selfy pictures so much that reading is...