lynchfourtwenty's Likes Given

buy an nismotronicSA from me, convert to map sensor and don't worry about it anymore

Other than having a part flying around inside you bell housing, what go wrong... Hmm, need I explain?




The Check Engine Light (CEL/MIL) usually will not come back on right away for these ty...

Hey everyone. Fortunately, that's not mine. I'm back on SE-R wheels but man, that is super rough to have your B13 stolen. Hope it gets found.

VIIIIIIICTORYYYYYYYYYYYYYY!!!!!!!!!!!!!!!
AFTER FIVE YEARS MY. CAR. IDLES. COLD!!!!!!!!
Thank you so much family!!! Big thanks to BenFenner lynchfourtwenty and Vadim!!!
I'm sure there are more ...

First off, I think you've found the source of your cold idle issues. Having the IACV blocked off would certainly mess with your cold idle.

As for that plug, it is either an EGR solenoid, or evap...

Sad to say but they only stole it for the wheels smh.

As long as there is a tiny bit of air gap between the clutch cable and the clutch arm you're good. Don't want that TOB getting worn out early because the cable is too tight.

I didn't include paper work with your new unit since you already have one.. you simply follow the directions on the downloads section and you are good to go.



The software DOES self register ...

Everybody was slow. Kyle and I were staring at each other through our side windows on most of the runs we did. Our cars were so even it came down to reaction time. Awesome racing! Thanks Kyle!

I...

The only stock, AH3 B13 that ran hot-laps for about 90 minutes. Track was at zero prep level and tons of heat and humidity after just driving the car 30 miles there.

Tons of fun, and happy they...

This all day long. I would never recommend sticking a screw driver inside the differential. I believe there is a pin you could damage in the middle of the differential.

AS cheap as se-rs are to find, i would just buy a whole one

Get a gtir manifold with wastegate in the correct spot.

Dealer is the only place I have found them.

Part Number: 30506-M8002

[url= URL=http://s1274.photobucket.com/user/LAM-PARK/media/NISSAN%20OEM%20PARTS/30506-M8002/30506-M80021_zps930e7868.jpg.h...

Dude you have a lot of nerve. I vote for blacklist.

Do you have seat ring installed between gate and manifold ? it looks like another vband but its smaller and fits inside the gate.

Yes, but ill sell you a set of adjustable gears that wont fall apart, that wont loosen up and lose time. I have my set of CS Adjustable gears, just look them up if you havent seen them before. On...

it runs! i tried uploading a video to photobucket. it took forever then gave me a FAIL. so screw it. here's a couple stills.
[url= URL=http://s11.photobucket.com/user/Teal97/media/033.jpg.html][img...

I just bought an LSD Axle from Napa and it looked similar, less the center balance chunk, but would not fit into the transmission completely. It started in and then the gear teeth or main seal woul...

Can we get a indicator light for O2 heat? I use this for exhaust cam, and EGR for intake (yeah i kinda meant to wire it the other way, but oh well), be nice to be able to check cam activation with ...

The SR20VE motor is the future of the SR20 community.

When the SR20 community started, a Sentra that ran stock 15.8 in the 1/4 mile was insane. Now, new freaking minivans run better than that.
...

Speed Density Fueling

http://youtu.be/ww9C0TurPF0

NismoTronicSA Setup Video

I installed a N14 steering wheel in my NX. Had to shave off some plastic to make it turnable. Do whatever you need to do!

https://sphotos-a.xx.fbcdn.net/hphotos-ash3/931375_10200856253067180_148521466_n.jpg


Pic of the Miata Gti-r Swap Engine Bay