Thread: PAR Gear Sets Getting Ready To Be Shipped

It handles pleanty of abuse. It's worth the price Par Gear sets do make custom gearing also. There's a few people using them to around 30-45 psi and no problems with them what so ever. So if your tired of blowing those Factory nissan tranny's that this is the gearing set for you..

Thanks again miko for suppling another great product to this community..

Is this a sycromesh set?

yes it is.

and you can get any gear combo you want or tell me what you have and I can figure it out for you.

Here is a turbo gear set I was working on. It has a little custom gears with a little 94-96 G20T

Should be great for any car with 400-700 WHP

8000 RPMs with 23 in tires

-------------4.176
1. 2.40-------55
2. 1.65-------79
3. 1.21------110
4. 0.93------141
5. 0.73------184 OEM Nissan G20T 5th Gear

When i destroy all my spare P11 gear stacks i'm giving you a call.

sell them before you break them so you can use it to buy the gear sets

Dre,

How are these as far as the amount of power they will hold. If this is something that will take abuse then this may be something I consider for next winter.

I assume these will go into a old style box correct?

Well, they will hold alot more than stock gears or even B15 gears, Straight cut gear will hold more power as there is more surface area in contact and straight cut gears dont want to move away from each other like helical gears in the factory box which is one main cause of the third gear breaking.

Yes they go into the old box with on minor modification. The bellhousing needs to be drilled open where the maon shaft goes through as the shaft is larger.

I will PM you later on as I am curious about the cost of this.

costs listed below from this thread