Thread: Almost time for a dyno!?

So the ITB sr20ve build is done and I've been running around with it for about 2 weeks now. Rev limiter set to 4krpm, then 5k rpm after a week, and now 6k rpm for the last few days.

I've done a compression test before and after the 2 weeks run-in and it's gone from 1150-1250-1150-1250 to 1400-1450-1450-1450Kpa, so the rings seemed to have sealed okay.

I've done roughly 1000-1500km. Do you think it's ready for a full tune to 8krpm now or should I put more miles on her first?

You're getting 210 psi compression?

I'd take it to the dyno, no problem.

yeah 203-210-210-210psi.

This is with 16ve 86mm pistons.

did you change the oil? if so .. take it to the dyno

good luck.