The Convention will move forward regardless and big surprises is in the works so if you are there at this years convention, see you there, if not, oh well........
For a guy complaining my about ethug's, you sure are ethug ing a lot. I don't get this hostility against one and another and now trying to separate the community even more by calling some northerne...
I wonder how much support there would actually be if the convention (maybe 2016?) was held in Texas or somewhere NOT up north. I bet most up north wouldn't make the drive...even if all events, inc...
I'll be honest, I go to these conventions not for the cars, but for the people. I'm always the one drinking with the group and cracking jokes, hell I had the bar on 4 wheels last year and it was a ...
Kyle, this is the same information I have. Once the schedule is set, it is pretty much SET! Sanctioning bodies do NOT like to move around big boy events! The cost is astornomical and people with $$...
We are now Nismotronic powered. Played around with it a bit this weekend seeing how coil dwell affect idle and low load throttle response. Didnt get very involved though. I am converting now over t...
Never in my life would I have believed I would be where I am with this project. I am incredibly grateful for all the interest this community has shown. I am personally grateful to John at JK Tuning...
Apparently, they feel there is enough thread area to not change. Can't really second guess them since they make fasteners for practically for every motors. If you going to build a wonder engine, th...
Just clean it up really good and throw a VET head gasket ($75) and ARP head studs ($140). Good until the rods bend... Both are reusable after you pop the engine too :)
Contains unread posts
Contains no unread posts
Thread is closed
You have posted in this thread
Back to top