Thread: b14: where do you guys run your boost hose?

aftermarket a-pillar gauge:

where do you guys run the clear hose?

thanks

I ran mine through the friewall where the ecu wires come in.

if you do cut a hole or even if you dont beware of the firewalls rough edges when u run the line

the main harness hole that runs inside the fender? (idk if my hose is long enough :o



yea, i know..if i have to go that route i will put a grommet in there..i was just asking if there were any existing holes that i could use

We used a huge drill bit (same to drill oil drain in a DE block) to drill a hole in my firewall, right above my pedals. Ran every in-car device through that hole. Used a rubber grommet to protect from sharp edges. Worked out great!

-G

It's not near the fender, this is on a b13, it's kinda below the heater core and stuff. I have my gauges where my radio used to be. I consider pillar gauges a sign to thieves that says "I HAVE COOL STUFF STEAL ME". They also take away from the sleeper effect, but I think I could have a parachute on my car and people still wouldn't take it seriously.

ill keep looking for something thats already there..



i have tinted windows..and my car isnt pretty at all..looks like a beat up piece of crap on the outside..haha..all stock looking..not even a fart can or any type of exhaust..lol

found a spot! haha

ran it through the hole where the shifter cables go through..

auto...?

No sir! 5spd