Removing Oil Pressure Sensor
Hey Fellas. I tried searching but since our forum is fairly new I had no luck. I figure one of you on here has done this already.
All right so I was behind my motor and I noticed that the oil pressure sensor was slightly covered in oil. I figure I should take it out and seal it up with some thread sealant while I have the car up on stands. Now my question is how do you get it out without breaking it? I didn't see a place to put a wrench on it. The senor has the plastic connector piece and then a round plastic ring in front of it.
Any tips on this procedure would be appreciated. I didn't want to start on it and then break it.
All right so I was behind my motor and I noticed that the oil pressure sensor was slightly covered in oil. I figure I should take it out and seal it up with some thread sealant while I have the car up on stands. Now my question is how do you get it out without breaking it? I didn't see a place to put a wrench on it. The senor has the plastic connector piece and then a round plastic ring in front of it.
Any tips on this procedure would be appreciated. I didn't want to start on it and then break it.