All posts where Payu has been mentioned by other members.
1 |
Thanks...the full writeup and videos are not finished or uploaded yet...stay tuned!
Thats the basics...a full writeup is still in the works so check back...but it sounds like you may be giving so...
Going for 35+psi? Payu
May want to go with a slightly bigger turbo.
[URL="http://i1334.photobucket.com/albums/w660/sss4me/cpc_zps44b48496.jpg"]http://i1334.photobucket.com/albums/w660/sss4me/cpc_zps44b48496.jpg[/URL]
Payu
"We need some runners like these
So...
I exchanged pm's with Payu before we hit the Dyno to make sure we were set on the setup,Thanks Payu
I too tested an excessive with a q45,12" or so intake pipe and then lengthed it about 18" additional and gained 10whp without tuning yet. Payu is right.
Payu, thanks Payu, that car seems to take off quicker? The driver is 100%. That team is no joke.
Payu this was a base back to back. There was no tuning involved, no changes in any maps, or such. Simple uninstall the SSAC and install our header. When I mentioned tuned, is because we are install...
jagy Payu where can i get CS cam gears? would the JWT cam gears work good?
I just saw Jagy's threat and i want cam gears!! :bigthumbup:
Can these runs be in SAE correction factor rather than STD, please Payu?
Just basically fallow like if you going to build a Tri-Y header longer primaries and 2.25 choke..bud search for the Tri-Y header...this is what almost every one from PR are running making good numb...
cory
Payu
Plus some other folks to chime in on this.
Damn, another upgrade is in order! Crank is ok, Payu?
Payu Please PLEase PLEASe PLEASE read this, it will only take a couple of minutes
Revenge of the Nerd- Boycott Fakes!
I would say u might have to reshim ur head if the keep popping off. Now is it usually the same one that keeps popping of or different ones. Also Payu might be able to give u some hints on cam timing
Thanks, I think I'm going to give them a try, I'm not getting much power after 7000 rpms with the SR20VE ones
A forum memeber was just talking about these cams the other day, with regards to a similar setup.
Here are two posts by forum memer Payu: [url= URL=http://www.sr20-forum.com/vvl/59845-high-comp...
1 |