Thread: Fun with TunerProRTv5 on a B13 RTv2 with Tunercode

I posted this on the other site in the Calumsult section, thought I would enlighten those of you that haven't seen the new capabilities

let me get that for this weekend haha

Oh, I have to add this as a disclaimer:

I'm in no way responsible for any damages you may incur as a result of using my timing and fuel maps. Remember that all setups are unique.

Thanks

i dont want your maps I want the ecu to let the bitch ass hater do some magic

LOL!

You know I would, but it's my daily driver. I'm not running the B14 until it's got tunercode capabilities. CEL's will drive me nuts.

its all good sir

If he shows up to the meet, do it up. It won't take him long at all. You're going to need a MOATS though.

Cliff, you went to a b13 RT instead of waiting for them to finish the b14 firmware?

I have a B13 RT and a B14 Basic. I did this with the intention of being able to use Tunercode on my B14 basic when it becomes available.

As an aside:

Using the tunercode bin presented another issue that I hadn't noticed until yesterday evening. My fans are on constantly. I looked at the fan control settings in the bin file and they seem to be fine. Loading the non Tunercode bin back into the ECU corrected this issue, but I REALLY need to figure out why the tunercode bin has this issue.

I'm going to e-mail Dave and see what he has to say

So I sent the bin to Dave to determine what it could be (constant fan issue), and apparently there's a bug with the a/c compressor flag. When you disable the a/c compressor, the switch sets to "on" which runs both fans at all times. Surely he's correcting it, but setting the flag to on for the a/c compressor will prevent the fan issue.