Originally Posted by ashtonsser 
yeah it all depends on power made as well, 300whp and below a 22X8X15 slick which im using is more than enough, 1.71 60ft, only heating the slicks up slightly in 1st gear, rev limiter launch with foot to the floor and quick dump, preloaded drivetrain before hand by slipping the clutch till everything locked up tight and front squatted down.
Above 300whp especially up there your gonna start spinning the smaller slicks through 1st and 2nd gear, above 400whp possibly even 3rd gear as well so a 24.5X8-9X13-15 will do just right, many people run them with no problems at all.
Im gonna be around 500whp or so and im gonna give my 22" slicks a shot just to see what happens and how they grip. Again rev limiter launches, just like before. It was actually pretty good, For not heating them up like a nice 2nd gear burnout they spun just a tad off the launch then ripped through 1st very quickly, 1.71 for my first time out is not bad on them, i feel i could have gotten a low 1.6 had i done a nice 2nd gear burnout to really heat them up. And that was beating out some of the awd cars off the line.
your gonna make 500 hp with what, that t28? haha, had to man. but its good to hear everybodys advice. i AMOST picked em up. so now im looking for slicks.
Be the first to like this post.
but yeah.....sounds like itll do for getting the groceries......
Back to top
