Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: 87mm SR20VE Dyno

+ Reply To Thread
Posts: 1-4 of 4
2019-07-08 06:54:50
#1
87mm SR20VE Dyno
Been a while since i posted on a forum!

Thought i would share this here with you guys.



My old SR20VE had oil starve on circuit and developed rod knock, so i assembled a new 87mm bottom end with 12.5:1CR CP pistons.

Here are the results after getting it tuned.

210 wheel horsepower / 240bhp Flywheeel @7740RPM
160lbft @5000


Black line = before tuning



SR20VE
N1 Camshafts
87mm 12.5:1CR CP Pistons
Xcessive Centre Feed Plenum on Custom Long Runner Manifold
Q45 Throttle Body
Big Tube Tri Y header
3" Exhaust

Last edited by SR20-AUTECH on 2019-07-08 at 07-16-07.
2019-07-08 11:34:44
#2
Bad-ass!!!!
2019-07-08 18:08:32
#3
Nice job!
Looks sharp.
Have you had it back on track yet?
2019-07-10 03:55:27
#4
Cheers guys.

Anglesey Coastal Circuit - Nissan Pulsar SR20VE 03/06/2019 (Feat. Audi RS6, Audi S4, BMW M3 )

This day was using my own road map (Nismotronic) , so basically the 'untuned' black line (190whp) on the dyno chart.

This engine now has an Accusump Oil accumulator installed, which should prevent any oil starvation issues.
+ Reply To Thread
Quick Reply
Thread Information
There are currently ? users browsing this thread. (? members & ? guests)
StubUserName

Back to top