All posts where D-Unit121 has been mentioned by other members.
1 |
D-Unit121 is correct. You need both bars for b15/p11 trans swap into b13.
I can tell you exactly how this thread goes. Half of the people will tell you to get a Passport, and the other half will say get a V1.
I'm in the V1 camp myself.
D-Unit121 have you tried YAV1? I...
D-Unit121 Nope. Starting to doubt that it's related to NEMU, since I tried hooking up my arduino flexconverter, and didn't get a signal... I will investigate it more this weekend.
Thanks D-Unit121. OnTheChip and JKTUNING , can you also chime in when u get a moment...?
Throwing this out there:
https://d37nk263jfz2p8.cloudfront.net/image/1/700/0/uploads/articles/gt3-car-numbered-54c83b3182b5a.jpg
Via this site: https://www.carthrottle.com/post/engineering-e...
D-Unit121 I merged your thread with this one so we can keep track of these instances.
This thread has been restored because the supposed rule against classified ads in regional sections was in an unenforceable state when this thread was created.
D-Unit121, please add all of the r...
I am allready using boost by gear. I am running gate pressure in the lower gears and still have spinning issues. With an EBC you can not run lower then gate pressure.
D-Unit121 wouldn't you be better off using the EBC setup then? Reduced power is reduced power. It shouldn't matter if its 1lb or 2lb on the boost or 5 degrees timing. Setup the boost by gear and yo...
D-Unit121 how close was the analyzer to the ethanol rating. I'm curious due to changes in winter and summer blend consistency.
D-unit has been helping me alot with the initial testing, kudos to him :)
On todays agenda, we need to get the RC-filter sorted out. D-Unit121 , I need some more values from you!
http://i.imgur....
D-Unit121 , clear your inbox!
Here's the schematic you're after:
http://i.imgur.com/BI3WI4x.png
Like D-Unit121 has mentioned you can use a generic output to switch to a alternate or secondary map to pull the additional timing and/or fuel corrections that are needed for the second stage.
I ...
D-Unit121 is who I've gone to many times and he gets the job done well
The question first is, what ecu or management system are you using?
Update: D-Unit121, just and update bro, i try to gamble to transfer the pin connedtors to another DE ecu and do the jumper thing too. So far when i try the chip it does work and it does not bouncin...
here is the video D-Unit121
http://www.youtube.com/watch?v=UC-UyT1hfe0&feature=youtu.be
D-Unit121 I was also thinking about it too. but when i try to burn another tune on the chip so far it performs erase , program and verify buffer and itshow success!. So it might be a right bin file...
D-Unit121
This is your wallets transaction history: https://blockchain.info/address/198K5dSmRgnnyz9Dq9Cb15dt5jAjVZgM2n
Do you see in your last transaction a company called Strongcoin? This is the...
D-Unit121 carliz -
Have either of you received refunds or your parts?
1 |