All posts where Mattick22 has mentioned other members
To be honest I wasn't even aware that the Mazda 3 had this so it didn't come across my radar. I will be trying to complete this sub-project and thread this summer when I go visit my car. I am not s...
Setup up is on its way from Doug Fab. It will be exiting through the bumper, in front of the passenger tire. Here is what I have for it so far.
https://farm9.staticflickr.com/8700/16750262937_56...
I think Doug Fab has experience with both resonator types.
As soon as I get this installed Ill try to upload a video with some decent sound. I wanted as quiet of an exhaust as possible, so Doug Fab built this for me. Here are the specs
- VRS 3" Piping Ki...
Here is the setup that Doug Fab fabricated for Maria. He used a regular "tee" setup because a "Y" would not have fit with the setup.
https://farm9.staticflickr.com/8735/16694427108_f1473e8e3c_o....
Doug Fab Can you post some pics?
I am having the same issue. The actual mount where the bushing goes is also a few degrees off. It should be straight up and down but the top is rolled clockwise a few degrees so the rear bracket yo...
All three gauge power wires? No not at all, that should be fine. speedricer actually did a badass job of the wiring on his, forgot where he posted it but its what I am going to emulate when I rewir...
canx2k Shawn B
Piping Hot Box On Its Way!!!
https://farm8.staticflickr.com/7531/16192506971_49aee09897_k.jpgPipe the fu/< down by Mattick22, on Flickr
canx2k Shawn B
Piping Hot Box On Its Way!!!
https://farm8.staticflickr.com/7531/16192506971_49aee09897_k.jpgPipe the fu/< down by Mattick22, on Flickr
Shawn B The FMIC piping is now sorted. Ill PM you for your address. Good Luck with the rest!!!
canx2k Andrew, Can you use any FMIC piping from a B14/GTiR application?
Also if you see anything in my classifieds let me know and ill ship it out to you.
Or if you need a tranny saver core let m...
I had some interesting news last week that will preclude me from being able to complete this project. I may not even be able to finish my car. The upshot is I may be able to offer some parts that h...
Dude you rock thanks! Now to find out the necessity of that Steering Angle Sensor...
Yea the one he missed was a charity event not a Drift Cup event. Yea we are hoping so too. He is getting the screamer pipes and a few other non essential things done in the meantime.
Is is being shipped Priority? He has already missed one event due to this and has another in two weeks...
Dam! JKTUNING its for Nick's car btw.
Kyle is right, I was thinking the front being available for some reason. I found this one through CL about a year ago. The guy was selling the car with them on so I had to grease his pockets a bit ...
You rock man thanks! Where did you get the pump? I have a feeling mine doesn't work...call it a hunch...
Once I get my rear end assembled and back in the car I will get back on this. KillerKrossover what kind of changes have you seen? Any improvements? Any advice?
I have two resister packs if you need one, 1 homemade and 1 OEM. JKTUNING may have an ECU for you, I mailed him some a few months ago. Also check ebay.co.uk for a GTIR harness, let me know if the...
I think it is possible for sure, especially if you already have the tooling or access to it. Is it the Mishi intercooler? With that warranty it would sell it easy I would think. I would look in to ...