All posts where zeneffect has mentioned other members
20v valve cover hose to block replacement
Those are the magic words. Thanks!
Do these address this issue?
http://www.sr20-forum.com/driveline-tech/64081-ultimate-6-speed-swap-thread-parts-instructions-results-8.html#post909151
KLUTCH b15azn
Do these address this issue?
http://www.sr20-forum.com/driveline-tech/64081-ultimate-6-speed-swap-thread-parts-instructions-results-8.html#post909151
KLUTCH b15azn
Indeed. Dss had issues getting the axle in. This is showing an actual quality part. Me wants, no faceballs.
Pm me KLUTCH
https://s32.postimg.org/svy3vu6tx/20160723_122517.jpg
North East coast guys be jelly. They know this bolt.
RAMALAMADINGDONG
No replies to PM or email. Can I please spend some money with you?
javierb14
javierb14
PING PING PING
The problem with silicone hoses is not slippage, but permeation of coolant through the hose itself and evaporating off without any outward signs of loss of coolant. higher maintenance for sure.
nsusammyeb
the fact that these don't fit does not surprise me in the slightest. I have eyes and can see clearly.
so what is performance plus going to do to rectify this? Probably a whole lot of...
Need some sort of verification that I'm not forgotten about or hoodwinked for 2 kits. We are not talking small beans here if you do the math.
BenFenner
Can anyone get a hold of him and have ...
one horse looks healthy, the other looks like the first horse has been eating all of its food.
7hp from a cat... Now you got me wanting lol!
Excellent work and numbers.
gio94sr20ve
Would you mind sharing the timing map? I'm interested in comparing what I've found with virtual dyno vs ...
The problem with locking down the IP is DHCP. The IP will change every so often (typically 2 weeks) and this would have to be done over and over... then there are proxies...
no, you want to mod the holes on the header side to mate with the cat. just copy the gasket to the flange and drill out the holes till they are slots going towards the pipe. you don't need a lift...
eggman
pre-drill out the flange that goes to the cat, and swap on a belt that moves the alternator down. if the alternator is at the top of its adjustment range, you need a shorter belt, if its i...
yes, and ive already begun collecting parts too :P
right on, i was looking at turbo mufflers before you posted this up. my concerns are though #1 zero sound clips though i do know turbo style mufflers are WAY quieter than straight through for obv...
4pk775 was a winner! So ve + gspec crank pulley = 775mm length fits and gets the alternator way out of the way
there is a trick to getting it on and it requires 2 people. 1 can be whoever, even ...
4pk775 was a winner! So ve + gspec crank pulley = 775mm length fits and gets the alternator way out of the way
there is a trick to getting it on and it requires 2 people. 1 can be whoever, even ...
4pk775 was a winner! So ve + gspec crank pulley = 775mm length fits and gets the alternator way out of the way
there is a trick to getting it on and it requires 2 people. 1 can be whoever, even ...