All posts liked by vorin
So, it has been a minute! But, finally started working on tuning it. It has been moved around a few times since coming to AZ. But now I am trying to get the engine bay cleaned up. Get it tuned ...
Hotel info and booking link updated
SR20 West Coast Convention 2022 - Rosamond, CA
Nissan needs to buy this thing back and put it in a museum!!!
I'll load the bumper and be there around 11, I think.
Way too much unnecessary hate for this car on this article. Is not the greatest car in this category but is not the worst. Toyota sells a lot of the new corollas and that car is boring and bland as...
Sounds like textbook buyers remorse.
Open the bottom end up, and if the bearing shells are still there, just replace with new ones of the same grade and button it back up. If the bearing shells are missing on any of the rods, either c...
Ah
Stock o2 sensor is a narrowband sensor. It will only output high/low voltage. It cannot be used to monitor AFR at all. It is only used for closed loop operation, to switch the mixture between r...
I drove it into work for the first time in a long time as a little birthday present. Sure the idle is terrible, it smells like gas when you get on it, it rattles your fillings out, and the factory ...
NOOB guide to installing cams in an SR20DE
Went racing at VIR to test out the new upgrades. I had set a goal of taking a second off my lap times and exceeded that by going 2 seconds faster with my fastest lap of 2:18. And coming home with...
Road & Track, July 1991 and random scans
That is most certainly an SE-R shift boot, the rubber version was what shipped in the first few weeks of production. I posted [url= URL=http://www.sr20-forum.com/classifieds-oem-parts/78244-wts-au...
You can delete it, but better yet would be to take a few logs of the issue and post those and your TCD and I am sure we can help get you squared away!
It was a "wash".... the stock valves flowed very close to the Supertech valves in the ported head. They did flow marginally less, but they were close. What I found out when I checked Supertech ...
OMFG...... 2 weeks to get valve seats, and install them...... :banghead:
anyway.... the head is back in my possession, and the new seats has been opened to the size of all the other seats... the...
small bit of explanation.... the above gif was taken from a Brit TV show called, "Are You Being Served", comedy about department store employees. The gif is from an episode where that mannequin ...
our specs....
http://ost.ebeans.ch/albums/userpics/10005/SR20VE_valve_guide_specs.jpg
of course in millimeters - so we must convert
.04mm = .00157"
.073mm = .00287"
So tight guides w...
I had to look this up.... still unsure, unless it is a synonym for cyl volume matching.... but yes, with new valves, and machine work to come, I may need to adjust chamber volumes.
Speaking...