Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: how to calum rt 2 version 0 connection - wiring and settings ?

+ Reply To Thread
Posts: 21-27 of 27
2016-10-17 15:58:17
#21
Black top GT engine original ECU is 64k, if you have 32k for blacktop it is incomplete bin.

yes 3j501 and 3j504 are same hardware, just later revision of software.

the bin you should try is http://www.daj.cz/r/p10ecu2europ11/cervena.bin (the red ecu - eu_p10_primera_gt bin 32kb)

then change maf type to 22680-2J200

P11 Gt engine has grey or red injectors? if grey injectors then also change injector size from 259cc to 333cc

datascan will only work when ecu is in car. When the ecu is in the car, and the car is running, change the rev limit and test, do not switch off to make change.

Did you check battery voltage? And the black and purple wire plug was plugged in?
2016-10-17 16:33:11
#22
oke maybe thats my problem,

i load the new file to the ecu and i am going to my car and try if its working.

[ATTACH=CONFIG]888[/ATTACH]

this is not okey ?

[ATTACH=CONFIG]889[/ATTACH]

the wire,s are connected it was for the picture on the back,

i also gone check the battery now
2016-10-17 16:35:14
#23
and for now i dont no how to fix the maf to the p11 maf but first priorety now is to load the bin on ecu,
2016-10-17 18:43:15
#24
This is the original bin for the ECU in which the CalumRT is installed

[ATTACH]890[/ATTACH]

This is the bin above with injectors changed to 333cc and maf changed to P11 type 2J000

[ATTACH]892[/ATTACH]
Last edited by yoshoto on 2016-10-18 at 00-37-36.
2016-10-17 19:10:00
#25
Here I have combined the necessary information from the nistune rom pack.

the ecu specifc parameters are at the top and the generic parameters are under that.

now you can compare with B13RT.xdf and add, edit or delete as required to get a specifc XDF for your rom

[ATTACH]891[/ATTACH]

you didn't tell me if the Injectors on your engine are red or Grey?
2016-10-17 19:12:42
#26
Thank u man

I think Greg one i am not 100% sure
2016-10-19 10:08:02
#27
yoshoto,

thank u for the support it is gray injectors and the car is running now and everything is working.
I have only problems to build the xdf file but thanks a lot you know what you are doing !!!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top