Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Question for all you audio guys on amps

+ Reply To Thread
Posts: 11-17 of 17
2010-05-20 20:20:38
#11
depending on the impedance of your speakers (all four in parallel) you can see 50w RMS
2010-05-20 23:14:31
#12
The amp is not a mono amp, it has the ability to be bridged, but it is not a mono amp.

The speakers aren't 4 ohms apeice but 4ohms per set.
2010-05-21 03:57:58
#13
Originally Posted by canx2k
I did tell you what amp I have, it's in my 3rd post (clarion apa2001)- and the box of the b/a speakers says the amp is supposed to be 25-275, it doesn't say either way about whether it's rms or not. Also, I did tell you right from the manual what the amp does

400w x 1 at 2 ohms
and it's a two channel amp




oh my bad , I must have been asleep,,, not the best choice for mids and highs


Originally Posted by Tommy
That amp is a mono amp....

Clarion U.S.A. | APA2001




2010-05-21 17:38:17
#14
Originally Posted by canx2k
The amp is not a mono amp, it has the ability to be bridged, but it is not a mono amp.

The speakers aren't 4 ohms apeice but 4ohms per set.


hyperlink to specs on said amp?
2010-05-22 14:09:42
#15
Originally Posted by unijabnx2000
hyperlink to specs on said amp?


Your link was correct, but I think you may have looked at the incorrect amp in the pdf, there are I think 2 or 3 listed, mines' the 2 channel 400W peice
2010-05-22 17:07:29
#16
so yours is the APA250
(since you say your isnt a monoblock, and its not a 4 chan)

With all 4 speakers in parallel you (two 4ohm loads in parallel is 2 ohms) should see 25w RMS to each speaker (about 50w RMS each channel)

Since its a 2 channel amp you obviously wont have any fade, you will only have balance.
2010-05-23 17:08:43
#17
Originally Posted by unijabnx2000
so yours is the APA250
(since you say your isnt a monoblock, and its not a 4 chan)

With all 4 speakers in parallel you (two 4ohm loads in parallel is 2 ohms) should see 25w RMS to each speaker (about 50w RMS each channel)

Since its a 2 channel amp you obviously wont have any fade, you will only have balance.




+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top