Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Does anyone make an EGR delete kit anymore?

+ Reply To Thread
Posts: 1-10 of 25
2014-08-17 22:10:53
#1
Does anyone make an EGR delete kit anymore?
I've tried searching but came up empty handed.
The only kit i found was from Nissport but it appears they are no longer making these.
Does anyone know where I can get one for a highport?
2014-08-18 09:26:31
#2
Hmmm, I made my own, but I think someone like Custom Steel must still make one. I bet if you give Greg V at Gspec a call he probably carries them.
2014-08-18 18:15:39
#3
Originally Posted by Will
Hmmm, I made my own, but I think someone like Custom Steel must still make one. I bet if you give Greg V at Gspec a call he probably carries them.



How did you make your own?? Is there a thread?
2014-08-18 18:29:43
#4
Originally Posted by gomba
Originally Posted by Will
Hmmm, I made my own, but I think someone like Custom Steel must still make one. I bet if you give Greg V at Gspec a call he probably carries them.



How did you make your own?? Is there a thread?


I pulled off the two EGR flanges and traced them onto 1/8 inch thick aluminum. Drilled the holes and cut them out with a jigsaw or something stupid, then I smoothed out the edges with an angle grinder until they were just right. This was a bit of a PITA though because the block off flanges don't have much room between the gaping holes in the manifold and the edge of the flange surface. I made gaskets with electrical tape and bolted them down, they've been on for 3-4 years.

Oh, and I couldnt get the EGR tube out of the stock header so I cut it off and welded it shut.
2014-08-18 18:35:24
#5
Originally Posted by Will

Oh, and I couldnt get the EGR tube out of the stock header so I cut it off and welded it shut.


Ya I've heard about this issue. Mine is pretty damn rusty I think I'll have to do the same thing :/
2014-08-18 22:19:29
#6
Originally Posted by gomba
Originally Posted by Will

Oh, and I couldnt get the EGR tube out of the stock header so I cut it off and welded it shut.


Ya I've heard about this issue. Mine is pretty damn rusty I think I'll have to do the same thing :/


I did it in the car with a flux-core splatter welder and no mask (I just aimed and turned my head)... it's pretty funny looking but I got it sealed up, I should probably post a pic in that "Ghetto fix" thread
2014-08-28 22:01:52
#7
Re: Does anyone make an EGR delete kit anymore?
[IMG[/IMG]
2014-09-02 18:19:17
#8
Are you selling this as a kit?
2014-09-02 18:53:06
#9
Made it the other for my car. Not selling as a kit
2014-09-02 19:35:00
#10
loren makes them (DMSentra) on the g20.net
+ Reply To Thread
Quick Reply
Thread Information
There are currently ? users browsing this thread. (? members & ? guests)
StubUserName

Back to top