Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: ICHIBA wheel spacers?

+ Reply To Thread
Posts: 1-5 of 5
2013-01-12 00:22:12
ICHIBA wheel spacers?
Has anyone used these? I'm looking again for spacers but don't want to go the route of replacing all the studs. I know there are set's out there with the studs attached to the spacer and you use nuts to attach the spacer to the stock studs. If not these what other options out there. I know that H&R only does it with 25MM and over.

Ichiba V2 20mm 4x100 Hub Centric Wheel Spacers Acura Integra DA9 DC2 90 01 | eBay
2013-01-12 01:23:31
waybne i am using exact same spacers as thesee...20mm in the rear..althought thoose look like they have an 59.1 hub adapter as well,where as mine where machined to 59.1 hub bore....and mine doesnt use a LUG nut rather a LUG KEY to tighten them down. and were half of the price.

but anyways you shoulnd t have any problme with thoose...just be sure to check them every ,idk once in a while

kinda like these..
Last edited by PEDRONX2k on 2013-01-12 at 01-25-13.
2013-01-12 02:28:15
Quit being a cheapass and get the H&R
Way less weight than all those lugs too.

2013-01-12 05:54:25
I'm with Jay on this, except go one step further and get yourself the ARP studs to go with your H&R spacers. Then you will have done this right, and you will only have to do it once.
2013-01-12 13:11:45
Yup,I've got 20mm H&R spacers,and they came with the longer studs.No problems whatsoever.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top