Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Interest in bumpsteer Eliminators?

+ Reply To Thread
Posts: 1-4 of 4
2014-04-22 17:13:39
#1
Interest in bumpsteer Eliminators?
We might be doing a limited run of bumpsteer eliminators depending on interest and pricing. We are in the process if getting things quoted for final pricing but we should be in the $150 range per set. These would fit the B14 & B13 and can be made to fit the P10 by using the B13 inner tie rods. Not sure about the P11 but i assume the same is true.

Similar to these.
http://www.sr20-forum.com/bolt-bars/30241-bumpsteer-kit.html

Post if you are interested in a set.
Last edited by squirlz on 2014-04-23 at 20-12-58.
2014-04-22 17:19:27
#2
I am more interested in what it will be made of and how you will accomplish this.

I have only driven ~2400 miles in the P10 and had zero to very little bump steer as stock. Unless the difference in how much you lowered your car vs mine is that extreme to cause bumpsteer.
Last edited by Kyle on 2014-04-22 at 17-20-52.
2014-04-22 18:00:09
#3
It is mainly for the B13/B14 but can be made to fit the P10 as stated. You may not need them in your P10. They will be similar to the Octotat version.

I never drove my P10 with out them so I do not know if they are any better than the factory tie rod ends or not for the P10. I know the B13/B14 can benefit.
Last edited by squirlz on 2014-04-23 at 20-11-52.
2014-04-23 18:52:57
#4
Aren't you at -1.5 degrees camber?

OEM is plus or Minus ~ 0.5 degrees camber

- Camber is gained via suspension compression / wheel turning (when talking about the front multi-link suspension that many folks dislike here)
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top