Thread: whats going on?

updated my nismotronic just now, and none of my tcd's are working right.. i can create a new one an its fine tho???

ok some are and some aren't then they will work then they wont.. btw feb is gone, is this because your getting ready to do the sa stuff?

What version are you running? I'm not seeing any new updates I'm at 2.28.1. Unless you had a REAL old version, then it should be working fine with your TCD's (it is for me at least )

Skynet?

I saw an update too, but I didn't download it as I thought it was the SA update and I haven't converted to a blow through MAF yet. Want to do that first.

Was it about a 12 MB download, Lynch?

I am on 2.28.1 and everything seems to be working ok on my end, maybe the file got corrupted?

I am going to release another update in a few mins.

Also, try deleting your prefs file and give it another shot.

EDIT: 2.28.2 is up.. it is literally just a rebuilt version of 2.28.1

If this continues to happen, send me your prefs file and I will see if it is a conflict somewhere.

If it continues, I will just revert back to Feb's revision and keep it there.

Are we getting closer on an SA release? Need to plan to do my MAF conversion, and I want to make sure that happens before or around the same time the SA release comes out.

ran the update again, same thing.. shits kind of pissin me off i had a few things i wanted to do today...

From what I understand, SA can be be set up with MAF or MAP, so you would not have to convert to MAP/IAT imediately in order to run SA version

I'm not converting to MAP right away. My IC piping is still setup for draw through. Once I get the SA version, I'm going to go down and get a dyno tune... need to be blow through with my vent to atmosphere BOV to get a good tune.

Did you invert your RPMs on the fuel table? Does it make it easier, or is that just the way your used to seeing it?