Thread: WI: Rear beam bending?

Is there anyone in Wisconsin that does this?

I wish there was.

That's what I figured....Damn it. I really want this done. I just wish more people did it. Would be nice.

Is there anyone that doesn't need to be flown out from Colorado that does this?

lol, I wish someone else would make a setup and have the experience to do it, I'm sure someone could. It's a simple concept.

I wonder if we would have enough people in the WI area to do this.

Maybe Con, Ben, myself, Wayne, maybe Nismo sunny, and someone I know who is not a forum member but does circle track racing with a b14. I can cover Steve's hotel cost with my job

I'm down if Steve still does this.

I'm down for it also, I'll just make the drive over there.

Ok well if there is enough interest I don't see why we can't get this done...

I just have a small request that we hold off if we are going to all do this at once. Seeing that I'm moving up there in less than 2 weeks and will be low on funds for a bit until I get settled. I'm sure this won't be an issue for a little longer since this was just brought up.

Cool?

Cool with me, funds are low on my side as well due to my build. Maybe mid summer?

The OP should make a list of the people interested so far that are in this thread. No? I will be ready to get this done within a few weeks. So hopefully we can get this done maybe before the convention rolls around. Looking forward to do a lot of spirited driving and maybe do some road racing.