Thread: What sensor is this?

On the front of the transmission bellhousing, circled in red. This is on a P11 70V trans. Crankshaft position sensor? Mine is cracked and would like to order a new one.



LMK!

Branden
aka hawaiiaNX

if i remember from doing mine crank position sensor? is it long and has like a magnet at the tip?

Reverse lights indicator? Shrug, I think thats in that vicinity but it prob is the crank position

I'm thinking so, though it seems like it would be right in the vicinity of the teeth on the flywheel so it can't be too long I wouldn't think. Will pull the spare one out of my other trans to take a look.



Pretty sure reverse light indicator is one of the ones that is underneath the trans. That and the neutral position sensor or whatever it is called. I'll pull my spare one out though and that should answer it.

Thanks all!

Branden
aka hawaiiaNX

Random pic that I found online. Inner edge of sensor has been circled in red.



I will still pull my spare one out after work and will upload pics when I can.

Branden
aka hawaiiaNX

Must be the crank position then with that photo. I remember back in the day, if you had a 98-99 SR20 you'd get a MIL if you got a lightweight flywheel because of that sensor, the later ones had it, and it looks like thats close to the right spot

it is crank position sensor 100% sure

Sounds good Gentlemen! MUCH appreciated! Will be putting in an order for one of these ASAP.

Branden
aka hawaiiaNX

i got mine from rock auto. be careful with spacing. when i di my clutch i threw it in and didnt know it would hit the flywheel. snapped it and after talking to pat Klutch realized i had to use washers as spacers. it works fine now and like he told me enough not to hit but not too many its too far. i found a washer that slid over it at lowes and got a few. put one on insert and i forgot how we turned the crank to make sure it didnt hit. just repeat till clear.