Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: What's A Good Set Of Rod Bearings To Get ?

+ Reply To Thread
Posts: 1-10 of 17
2012-04-07 20:02:38
#1
What's A Good Set Of Rod Bearings To Get ?
I have a slight tapping noise on my sr20 . I only hear it after 4 rpms . Now I'm looking into rebuilding the bottom end . I've been searching for rod bearings . I found a few but I want more opinions on what the other members are using and recommend .

edit - what size width is a jdm de rod bearing 17mm or 19mm
Last edited by SunnyB13NJ on 2012-04-17 at 12-12-57.
2012-04-07 20:15:06
#2
oem from gspec
2012-04-07 20:52:29
#3
Oh ok I'll ask him
2012-04-07 21:04:37
#4
ninja Edit nevermind.
2012-04-07 21:18:16
#5
acls work great i have also used clevites with no problems
2012-04-07 21:25:07
#6
I've been leaning towards them . Racing bearings
2012-04-08 11:32:53
#7
acl. Done.
2012-04-08 12:13:17
#8
If the motor is starting to knock consider getting standard size bearings. You can't go wrong with OEM.
2012-04-08 13:46:21
#9
it could also be a bad wrist pin i just recently had a friends car do this.
2012-04-08 17:07:59
#10
What caused the issue first? Dont go throwing money at it without figuring out how it started...lack of oil changes, driving it with low oil levels, high milage, just purely getting the ish pounded out of it...it could need more than bearings
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top