Thread: 6-speed swap stuff

Hey greg. I am going to need all that stuff from the estimate you gave me.
Flywheel & swap kit.

I also need to source or find out which crank sensor I should be able to use for this conversion. Also I do need just a couple parts for the swap as well. The clips/retainer pieces that hold the cables on the transmission are gone. The clips look like the kind on the brake hoses that clip them to the strut. Best way I can describe them. But they require two different size clips for the shifter cables. I need both of those clips.

Also greg we really should get a clutch hose as well. I can have one made locally, but if you happen to know what length is required it would be helpful. Or you can just have one made and sell it

Lock Plates:
36406 7B405 x3 (two on shifter, one on tranny)
36406 9B000 x1 (other on tranny)

If I recall correctly the clutch hose is 13" from the hard line to the slave. There are a few diffrent people that make them in a nice braided SS.

Your brake hoses use the same size fittings from the hardline to the banjo fitting on the slave. You can use a braided hose if you have some laying around. Thats what im using.

Or just have a nice braided hose made from the master cylinder all the way to the slave and get rid of the hardline completely. They sell hoses like this for 240's that go from the clutch master down to the slave. It might be too long but it will give you enough length to tuck it away nicely through the fender well then down and around to the trans.

Shouldnt be hard for a local shop that does hydraulic lines and fittings to make one either. It uses a standared brake fitting on the master and i forget the size banjo on the slave. All very standard pieces

will post in your other thread instead of here.

I sell the stainless clutch line already. There is probably no need to change to a stainless line all the way from the master.

Greg, would those work on a P11?

absolutely.

Absolutely Amazing is what I say then . I'll pm you with an order after I see what else I need