Thread: Injector Dynamic ID1000 install with factory seats?

Can I install the ID1000s with the factory injector seats or do I need some type of custom seat? How are you guys installing them with the factory injector seats? Pics or detailed description is appreciated. I did find a thread on the topic just would like more opionions.

EDIT: nevermind found this if anyone else is looking http://www.sr20-forum.com/turbo/66466-fitting-id1000s-stock-injector-ports.html

ill get some pics up later. but you need special seals for bottom of inj that ID sells. I stock these due to the fact that a lot of guys just buy the ID1000 and don't by the ID1000kit that is specific to FWD SR20.

The kit includes everything needed for FWD SR.

hmu I can send you what you need. im assuming you have the ID1000 already?

yup I already have the fwd sr20 specific injectors p/n 1000.13.07.60.14.4 with the extra oring. i couldn't get them to seat with the provided id oring. My factory seat goes all the way up to the black portion of the injector. i will upload pics when i get home.

oh if you have the specific kit. you are all set. just take the green orings off the bottom and install the square cut seals. use the stock rubber cushions also.

any pics installed doug? thats what i did but was unsure how far down the injector should go... should the id supplied oring(the one you have pictured) squeeze into the factory seat??

exactly the square oring will go on the inj then install factory bushing around ID o ring then install into intake.

heres how mine look when installed. Note this is a VE application but I would think highport is the same.

http://i1019.photobucket.com/albums/af312/sr20boosted/Fab/DSCF0432_zps65235061.jpg

http://i1019.photobucket.com/albums/af312/sr20boosted/Fab/DSCF0431_zps87171f44.jpg