Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: fuel pressure

+ Reply To Thread
Posts: 1-10 of 10
2012-03-19 00:43:18
#1
fuel pressure
is 55 psi considered high on a stock fuel pump?
2012-03-22 23:26:10
#2
since no one else will touch this.....
the stock fuel pressure is 3 bar. 1bar=14.7psi. 3x14.7=44.1
a stock fuel pump can support higher than 3 bar. so what is it you need to know?
hope this helps.

sent from Orcas Island, Wa.
Last edited by Teal97 on 2012-03-22 at 23-29-40.
2012-03-23 13:55:44
#3
I dont know if 55 is to high, but im using 47psi and had no problems with the stock fuel pump.
2012-03-30 05:53:07
#4
I don't believe so. what mods are you currently running? are you on the stock ecu? I have a jwt ecu in my b14 and I'm running a walbro 255, My fuel pressure is set to about 36+/-psi @ WOT.
2012-03-30 06:22:43
#5
It shouldn't be a problem. I run my stock fuel pump at that psi and have been for months. Will continue to do so until I have time to swap the engine harness, install walbro, and tune.

You got a wideband hooked up to see if your rich or any particular reason you running 4 bar?
2012-03-30 13:17:11
#6
Engine was running way lean. Using fpr to compensate until i can put it on the dyno and tune
2012-04-10 03:08:36
#7
Mine does the same only on wot, going to get an adjustable to compensate
2012-04-11 01:00:43
#8
i just didnt want all the back pressure to blow out the pump or something.
2012-04-11 01:18:14
#9
Aren't you reading 55 at idle though? I remember seeing your fuel pressure being way high at idle the other day.
2012-04-11 01:27:38
#10
yea, well the afpr isnt working right with vacume. im guessin it is rising rate. im gonna try to bump down to 50 psi tomorrow and see what happens
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top